To recap on the card set up, the most important is card type and use. Here again, you have choices. You have to select what card inside that selection. If you do not know which card you have, or if you have a card which is not listed over here, in that case use Custom 1/Custom 2, and adapt temperature and the speed to have the card printed nicely and without being bent. When this is done just be sure, depending your ribbon, what you want to do with the front and back for the black, what you want to do with the front and the back if you have a ribbon with inhibitor. When you are all set up here, including encoding and black cable optimization, it is very important to click on Apply and Ok. Saved and usable for the next time.